PVC Boots Line 300
Panther boots in PVC Line 300
Reinforced buttress for protection of the heel and easy to remove the boot upper part of the shaft with grooves system on both sides for easy grip, the color of the upper and upper is black and the sole of the boot is beige, the height corresponds to the type of high-top boot with an average range of 359 mm. , heel with a height of 26 mm +/- 2mm, the sole with an embossed design that offers a non-slip effect, reinforced upper with embossing, as well as the heel counter with 2.8 mm tape in upper parts, to avoid tearing; 22.9 mm reinforcement on the back. Ergonomic design and materials of direct injection of PVC (polyvinyl chloride), of high resistance and great flexibility; 100% waterproof; nylon inner stocking without pleats


Qty

Product Comments

There is no comment for this product

Descripción

  • DESCRIPTION: PANTANERA BOOT
  • GENERAL: COUNTER FOR ENHANCED PROTECTION AND EASE TO HEEL BOOT mismatching TOP OF REED WITH GROOVE SYSTEM ON BOTH SIDES FOR EASE OF GRIP
  • COLOR: OF THE ASSEMBLY OF THE CANE AND THE CAPELLATION IS BLACK / THE COLOR OF THE SOLE OF THE BOOT IS BEIGE.
  • HEIGHT: CORRESPONDS TO THE TYPE OF HIGH ROD BOOT WITH AVERAGE RANGE OF 359 mm.
  • HEEL AND SOLE: HEEL WITH HEIGHT OF 26 mm +/- 2mm. OUTSOLE WITH A RELIEF DESIGN THAT OFFERS ANTI-SLIP EFFECT.
  • CAPELLADA: REINFORCED WITH RELIEF, LIKE THE COUNTERFURT ROD: WITH TAPE IN TOP PARTS OF 2.8 mm, TO AVOID TEARING; REINFORCEMENT IN REAR OF 22.9 mm.
  • DESIGN AND MATERIALS: ERGONOMIC DIRECT INJECTION PVC (polyvinyl chloride), HIGH
  • RESISTANCE AND GREAT FLEXIBILITY; 100% WATERPROOF; NON-PLEATED NYLON INNER STOCKING
  • TECHNICAL DATA: - HEEL AND OUTSOLE WITH RESISTANCE TO 118 mm3 ABRASION - RESISTANCE TO
    BENDING AT 150,000 CYCLES OF 9.93 mm
    -HARDNESS (SHORE A-15 sec): a) IN THE UPPER OF 62.8 b) IN THE OUTSOLE OF 63.5
    - DENSITY IN g / cm3: a) IN THE UPPER OF 1.18 b) IN THE SOLE OF 1.12
    - RESISTANCE TO THE EXTRACTION OF OILS BY SOLVENTS (UPPER AND SOLE):
    A) MASS LOSS IN GASOLINE (%): a) 0.07 CANE b) 0.01 SOLE
    B) LOSS OF MASS IN VEGETABLE OIL (%): a) CANE OF 0.0 b) SOLE OF 0.0
    C) LOSS OF MASS IN MINERAL OIL (%): a) CANE OF 0.0 b) SOLE OF 0.0
    D) LOSS OF MASS IN WATER-SOAP (%): a) CANE OF 0.0 b) SOLE OF 0.0
    - AIR LEAKS: NO EVIDENCE OF AIR LEAKS
    - THERMAL STABILITY: NO DEFORMATION OR APPARENT DAMAGE
    - TENSION PROPERTIES FOR THE ROD:
    a) ELONGATION 4.76 Mpa (Standard requirement: Min 1.5)
    b) ELONGATION TO BREAKAGE (%) of 420.72 (Requirement of the standard: Min 170)
    - SOLE AND UPPER ADHESION N / cm of 61.03 (Requirement of the standard No less than 30)